Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

rk
New Member

Problem saving config on C2600

After making a few changes on a C2600 router I'm not able to wr it to the NVRAM. It gives the following error message:

"% Configuration buffer full, can't add command:........Aborting save"

Any clues? and work around?

4 REPLIES
Silver

Re: Problem saving config on C2600

You can try this:

Use "service compress-config".

Before doing this save your config into your flash using:

copy running flash:myConfig

Do 'dir' to confirm your config is written to flash.

Hope this helps.

rk
New Member

Re: Problem saving config on C2600

Thanks. I'll try it.

Bronze

Re: Problem saving config on C2600

Not the same error message I remember but I ran into a problem when my config go too big for nvram. Try adding "service compress-config" in global config mode and see if it will save after that.

rk
New Member

Re: Problem saving config on C2600

Thanks. I'll try it.

109
Views
0
Helpful
4
Replies
CreatePlease to create content