Problem saving config on C2600

[rk]

After making a few changes on a C2600 router I'm not able to wr it to the NVRAM. It gives the following error message:

"% Configuration buffer full, can't add command:........Aborting save"

Any clues? and work around?

[rais]

You can try this:

Use "service compress-config".

Before doing this save your config into your flash using:

copy running flash:myConfig

Do 'dir' to confirm your config is written to flash.

Hope this helps.

[rk]

Thanks. I'll try it.

[rjackson]

Not the same error message I remember but I ran into a problem when my config go too big for nvram. Try adding "service compress-config" in global config mode and see if it will save after that.

[rk]

Thanks. I'll try it.