I have a cisco 7204 VXR router with IOS 12.1.(1a) and 64MB of RAM. There are 8 serial interfaces connected to this router. The problem im facing is that this router hangs intermittently and goes to the boot mode.Then i have to turn off the router for sometime and then again turn it on and everything works well. It doesnt happen frequently or periodically. Can anyone help me out from this.? any help from you will be of great hep to me.
Is the router hanging or reloading (crashing) ? Anyway, hang or crash, it is possible that this is a software problem. The software running on this machine is quite old and not the most stable (first 12.1 release). I would recommend to have the router upgraded. Also, when the problem occurs, are there any error messages displayed on the console ? Is the router responding to keystrokes ?
the router reloads and comes to boot mode after relaod. and i need to manually change the config-register value from 0x2142 to 0x2102. i have not plugged on the console. the router seem to perform noramally after the reload.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...