I have problem with the 8 port analog modem. I configured the cisco 2610 router to accept dialin remote users. the router is loaded with latest modem firmware. the problem occured everytime the router is restarted, once restarted all modem ports are not answering to remote modem. when I view the line status, all tty port are indicating "A" I tried to reverse telnet the modem but connection refused by remote host. the modem only accepting calls when reverse telnet to the modem port is successful and the "A" on the tty line is remove. but it took a lot of time for the router before the modem ports become normal again.
If you see an "A", this means that we think there is a connection on that line. I would suggest you confirm your config (either "async mode interactive" or "async mode dedicated", and with interactive you should have the "autoselect" commands under the line, and either "modem inout" or "modem callin" on the lines, too), and you should ensure that you are running recent IOS sw, at least 12.1 latest.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...