Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problem with a priotrity list

Hi,

I have a router 2620 and i want to give him some priority on some flow. So i decide to use the priority-list command, but that don't seem to be good.

I try to use a netmeeting between 2 compueter. For see if it's work i launch a some ftp for test if the priority list make his job.

This is my command tha i enter:

(config)#priority-list 1 protocol ip hight udp 7648

(config)#priority-list 1 protocol ip hight udp 24032

(config)#priority-list 1 protocol ip hight udp 56800

(config)#priority-list 1 protocol ip low tcp 21

(config)#priority-list 1 default normal

(config)#int fast 0/1

(config-if)#priority-group 1

I don't know why but the netmeetin lag, and i think that the priority list doesn't work

So i try the commande

#debug priority

And nothing go on my screen

Thanks for your answer

2 REPLIES
Bronze

Re: problem with a priotrity list

Is there only one router or is there another one on the ohter side of a wan link? Did you set priority there too?

New Member

Re: problem with a priotrity list

Hi,

Oups i forgot, yes there is another one on the other side, this is the same router (2620) and i set the same priority on the 2 router.

I set priority on the interfaces which establishes the link between the 2 routers

88
Views
0
Helpful
2
Replies
CreatePlease login to create content