I have a 2500 series router that goes into a loop when booting. The error message it displays reads:
Local timeout (control reg=0x118) Error, Address 0x2130002 at 0x1010AA0(PC)
I can go into ROM monitor mode, but when I set the configuration register to 0X2101 so as to boot from ROM, and initialise, it still goes into a loop. If anyone has had this problem, I would really like to know how you solved it. Thanks
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...