Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem with cat4003 vlans

In setting a up cat4003 I have 4 vlans configured through the supervisor's mod and when I go to the router module and type sh vlans it says that no vlans are configured. Anyone have any ideas why?

Also I can't get port 2 to stay up. When I type in no shut on the interface it goes up then down & down again. Again any ideas?

Thansk.

2 REPLIES
Cisco Employee

Re: Problem with cat4003 vlans

VLANs dont get propagated to the Layer 3 module. The L3 module is used to route between VLANs and you can find more on configuration details/examples on CCO at

http://www.cisco.com/warp/public/473/28.html

New Member

Re: Problem with cat4003 vlans

Thanks I've added this paper to my binder.

84
Views
0
Helpful
2
Replies