Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with Catatalyst 3548 XL and a 1000BaseTX Module

Hello,

I have a problem with upgrading a Catalyst 3548 XL-Switch with a 1000BaseTX Module.

After I put the GBIC module in the slot, i get a error-message in the VSM:

"Visual Switch Manager has detected a change in the device's hardware configuration and needs to redraw the device." When i click the "OK"-Button the message disappears and comes back after 3 seconds.

After i removed the module everything works fine.

My Software Version is 12.0(5)XU Enterprise Edition.

The following site says that the GBIC Module is supported by this Software Version: http://www.cisco.com/warp/public/620/ios_12_0_5_xu.shtml

Any suggestions?

Thanks!!!

1 REPLY
Bronze

Re: Problem with Catatalyst 3548 XL and a 1000BaseTX Module

As for the Visual Switch Manager, it needs IOS code 12.05(XW) or later in order to see the copper GBIC.

http://www.cisco.com/warp/public/473/59.html#t2

258
Views
0
Helpful
1
Replies
CreatePlease login to create content