I have created Etherchannel on Cisco 3524 between port 1-2, 3-4, and 5-6 and they are connected to 3 Dell Servers.
Server 1 (Dual Nic) connected to port 1-2
Server 2 (Dual Nic) connected to port 3-4
Server 3 (Dual Nic) connected to port 5-6
The problem is after a few minutes, the 3 servers would lose connection. Another few minutes later, the connection would be good. And another few minutes, the connection is lost. It is basically intermittent.
Port 24-25 are also Etherchannel and connected to another cisco switch, and it is working fine. The problem is only b/w servers and the switch.
I thought it was the Spanning tree, so I disabled these ports from learning (STP Learning = Disabled), but the results were the same.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...