I have a Cisco 2610 with NM-16AM. This registry data (ppp, user, etc) in to the syslog to operate in a WINDOWS NT Workstation, but then 50 or 60 users access, it's stop. I have to reload the router for to restart the registry
How do I can to operate the registry in permanent form ??
Make sure youre not logging to the console too as this can overwork a busy router. Also, check your directory permissions and disk space to make sure the logging host is not running out of space. Finally, make sure the log host service isnt stopped, it should reside on the same physical wire as the router (not over a slow/unstable link) and the pc is fast enough to keep up with the traffic.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...