Problems about cisco switch communitcation with intel switch
Does any body can tell me ,How to config cisco 3 layer switch (ex 2948g L3) make it as the core lan routeing equipment ,the layer 2 switch is cisco 2924 and intel 510t ,Intel switch only support rip 1 and ospf wan routeing protocol and 802.1q vlan protocol, how to configure the cisoc 3 layer switch to make all vlan in my lan area to work correctly.
Re: Problems about cisco switch communitcation with intel switch
The 2948G-L3 does not support VLANs. It's more like a router and you'll need to use bridge-groups. From the L3, create a dot1q trunk to the 2924(if your hardware/software supports it). You can do the same for your Intel switch as well. The following pages on CCO should help
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...