I had cisco 6006 layer 3 switch. I have configured channeling in the 100BaseTx ports of the switch. I have configured 7 etherchannels each having two ports. On the System side, NICs are teamed using IntelPro utility. When I test the teaming configuration in the systems, an error stating that the STP is enabled on the switch and It should be disabled. I have made portfast enabled on all the switch ports in the etherchannel. I use to get the error messages interminently and not at all times.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...