Help !!
New switch - new native IOS!!
I have configured the basics ( after working out a router interface is the management LAN !! ).
My router has a vlan1 and vlan2 interface configured and I am running a routing process ( OSPF ) . Both Vlan's show up , line protocol is down.
It looks like I do not have layer 2 enabled, no matter what I do as regards other options spanning tree etc I can still not get these interfaces up ( also slightly confused how to put say a fastethernet port into a specific vlan !! )
Do I have to enable something on the supervisor engine to get layer 2 up ?
any advice appreciated!!