Problems installing a 4705R with ws-4513 supervisor iv
New switch - new native IOS!!
I have configured the basics ( after working out a router interface is the management LAN !! ).
My router has a vlan1 and vlan2 interface configured and I am running a routing process ( OSPF ) . Both Vlan's show up , line protocol is down.
It looks like I do not have layer 2 enabled, no matter what I do as regards other options spanning tree etc I can still not get these interfaces up ( also slightly confused how to put say a fastethernet port into a specific vlan !! )
Do I have to enable something on the supervisor engine to get layer 2 up ?
Re: Problems installing a 4705R with ws-4513 supervisor iv
Hmm - it would seem if I add a device that actually exista in the vlan then the router interface comes up,,, i.e - Ip address Vlan 1 10.0.96.1 - if I add a host 10.0.96.2 on an etrhernet port on the switch then the vlan line protocol comes up? Why !!! ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.