I just upgraded a 2600 router from 8 MB flash to 16 MB flash (that came from a working 3600). I know for a fact that the firmware for the router with the upgrade is good - I was able to upgrade a different router with no problem. However, with the new flash, the transfer of the code errors out with
File reception completed.
TFTP copy: operation terminated due to bad checksum comparison.
As best as I can tell, the flash is the same between the 2600 and 3600. Please let me know if anyone was able to successfuly do this. Thank you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...