Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

problems removeing clock rate command

I am trying to remove the clock rate command from a serial interface but get the following error:

FECPM PM doesn't support clock rate 0

If you have seen this before please can you help.

Thanks.

4 REPLIES
Community Member

Re: problems removeing clock rate command

Paul,

you've probably tried this, but on a c1700, you can simply use 'no clock rate xxx' (xxx is the rate you set previously).

-matt

Community Member

Re: problems removeing clock rate command

Thanks for that but yes i did try that command with and without the XXX. One thing to mention is that there is no cable attached ?

Community Member

Re: problems removeing clock rate command

the cable shouldn't mattter.. have you already removed the 'frame-relay intf-type dce' command (assuming that this is a FR connection) ?

Community Member

Re: problems removeing clock rate command

hey,

NO NO, cable does matter ...is the router 3640???, until you attach the cable to the interface, sh run will show clockrate xxx depending on the serial port type(1500 for serial and 2048 for HSSI)

attach the cable and do a sh run, you will immed see the diff.

Hope that Helps.

199
Views
0
Helpful
4
Replies
CreatePlease to create content