I have a 1720 / 32MB of RAM / 8MB of Flash / WIC-1ENET. The WIC-1ENET is connected to the Cable Modem (Toshiba PCX1100U) and the internal FastEthernet is connected to my internal LAN. The router does not draw a DHCP address from the cable modem, even though a PC configured for DHCP will draw an IP address. I receive the following error message from the router when using the "debug dhcp detail" command.
Thanks in advance,
*Mar 1 00:17:42.407: B'cast on FastEthernet0 interface from 0.0.0.0
*Mar 1 00:17:45.403: DHCP: SDiscover attempt # 2 for entry:
*Mar 1 00:17:45.403: Temp IP addr: 0.0.0.0 for peer on Interface: FastEthernet0
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...