Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems with PCMCIA cards on 6500

Has anyone had any problems with Cisco MEM-C6K-ATA-1-64M= on a 6500, the switch doesn't read the card in ROMMON mode but will with a none Cisco PCMCIA card, the switch is running ROMMON V7.1 which according to Cisco should work, below is a "sh mod"

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 2 Catalyst 6000 supervisor 2 (Active) WS-X6K-SUP2-2GE

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

1 0006.d65c.94bc to 0006.d65c.94bd 4.2 7.1(1) 12.1(27b)E Ok

Mod Sub-Module Model Serial Hw Status

--- --------------------------- --------------- --------------- ------- -------

1 Policy Feature Card 2 WS-F6K-PFC2 3.3 Ok

1 Cat6k MSFC 2 daughterboard WS-F6K-MSFC2 2.5 Ok

2 REPLIES

Re: Problems with PCMCIA cards on 6500

Hi Will,

In Rommon mode, you cannot access the PCMCIA cards. You can only boot it from there.

If you do like dir disk0:, it will give you error as in rommon mode its is not accesible.

HTH, Please rate if it does.

-amit singh

New Member

Re: Problems with PCMCIA cards on 6500

Amit

Thanks for the info

110
Views
0
Helpful
2
Replies
CreatePlease to create content