Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problen with ip

i have that configuration:

the interface of the first router:

interface Dialer1

ip address 1.1.1.2 255.255.255.252

encapsulation ppp

dialer pool 1

dialer remote-name Center-2

dialer idle-timeout 121

dialer string 6258700

dialer-group 1

ppp authentication chap

ppp chap hostname bdika1

ppp chap password 0 rtaui

!

and the interface of the second router is:

inter dialer18

ip address 1.1.1.1 255.255.255.252

encapsulation ppp

dialer pool 1

dialer caller 5629400

dialer-group 1

ppp authentication chap callin

ppp chap hostname bdika1

ppp chap pass rtaui.

the problem is that i can't to get each ather with ip .

why , its directed connected?

2 REPLIES
Bronze

Re: problen with ip

as i understood you can't ping each other so check extended ping to test link connectivity as below:

from first router :

Router A>enable

Router A#ping

Protocol [ip]:

Target IP address: 1.1.1.1

!--- The address to ping.

Repeat count [5]:

Datagram size [100]:

Timeout in seconds [2]:

Extended commands [n]: y

Source address or interface: 1.1.1.2

Hall of Fame Super Silver

Re: problen with ip

This exact same question was posted on the WAN routing and switching forum (before it was posted here). I have responded in the other forum. I suggest that we consolidate the discussion into the WAN routing and switching forum.

HTH

Rick

196
Views
0
Helpful
2
Replies
CreatePlease login to create content