I am trying to test a 1MB link end to end, is there a way I could give a loopback on the router rather than the CSU/DSU. There is a loopback remote command available, but this would require routers connected at both ends. But in my case at the remote end I have only a CSU/DSU & at my end I have a router & CSU/DSU. Thanks in advance.
Cisco support loopback on the router itself when it has build in DSU/CSU (loopback local, loopback dte). If external DSU/CSU is connect to our DTE port, loopback needs to be perfromed at DSU/CSU. Usually CSU/DSU has loopback button or command which can loop towards the DTE port on the router. Please refer to your CSU/DSU manual.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...