I am trying to test a 1MB link end to end, is there a way I could give a loopback on the router rather than the CSU/DSU. There is a loopback remote command available, but this would require routers connected at both ends. But in my case at the remote end I have only a CSU/DSU & at my end I have a router & CSU/DSU. Thanks in advance.
Cisco support loopback on the router itself when it has build in DSU/CSU (loopback local, loopback dte). If external DSU/CSU is connect to our DTE port, loopback needs to be perfromed at DSU/CSU. Usually CSU/DSU has loopback button or command which can loop towards the DTE port on the router. Please refer to your CSU/DSU manual.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...