PTP IMA between more then two sites.

[drush]

I am wondering if the Cisco IMA cards support the following setup.

Router A

8 Port IMA Card

4 PTP T1's (Two going to site with Router B and two going to the site with Router C)

Router B

4 Port IMA Card

2 PTP T1's going to Router A

Router C

4 Port IMA Card

2 PTP T1's going to Router A

What I am asking in the is that if Router A can support both Router B and C with a single IMA interface.

[gmarogi]

I guess you should be able to use point-to-point sub-interfaces with the IMA group. Check if this doc provides any clue :

http://www.cisco.com/en/US/tech/tk39/tk356/technologies_q_and_a_item09186a0080111162.shtml