Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Purpose of Network Management Port at C4503

Hi Ciscoer,

Could any1 here explain for me what the purpose of Network Management port at the Supervisor Engine IV? Attached with what the Network Management port? And how to InterVLAN routing with 4503 (any cisco link and sample?)

Thank YOu

HATO

3 REPLIES
Cisco Employee

Re: Purpose of Network Management Port at C4503

The management port is used for disaster recovery. If you delete all IOS images and if you do not have a flash card, you can use management interface to recover the supervisor. This port is not active when the supervisor is up and running and can only be accessed in rommon

http://www.cisco.com/warp/customer/473/149.html#image

Configure layer 3 VLAN interfaces to route between VLANs

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_13/config/l3_int.htm#1029700

New Member

Re: Purpose of Network Management Port at C4503

HI thank you before,

Hm....is it only for disaster recovery? No other purpose? Also have try to configure the L3 Vlan Routing. I have create a vlan called 2. I cannot ping the interface from the C4503(the shor interface vlan 2 show me that the interface and protocol down/down) but I can ping from the workstation.

Any suggestion?

THank you for your quick response

HATO

Cisco Employee

Re: Purpose of Network Management Port at C4503

For the layer three VLAN2 interface to be up/up, you need to have some device in VLAN 2.

http://www.cisco.com/warp/public/473/188.html

181
Views
0
Helpful
3
Replies
CreatePlease to create content