Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PVC Configured using old command

I am trying to edit a sub-interface. When I am at (config-subif) I want to change the QOS to vbr-nrt. However, I can't change any settings on the PVC. Any help??

2 REPLIES
New Member

Re: PVC Configured using old command

HI,

do you have entered tha PVC command under subinterface?

e.g.:

router#conf t

router(conf)# int atm0/0.200

router(conf-sub)#pvc 1/200

router(conf-if-)#vbr-nrt ........

This normal should work

regards Ulrich Marzoli

www.netaid.de

New Member

Re: PVC Configured using old command

I can't get past command -router(conf-sub) pvc 0/34

As soon as I hit I get the error message.

72
Views
0
Helpful
2
Replies