Hi all. I have a Cat6509 with multiple VLANs set up. I have helper addresses on each VLAN pointing at the correct DHCP servers so all clients can and do get IP addresses automatically, but my IBM Blade server farm is not able to PXE boot. The management server the blades want to speak to is in a different subnet from the blade servers and is already in the helper address statement, but none of them chat to each other unless they are in same subnet! Any ideas?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...