Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

QDM and ATM VC's

Hello,

we are currently using policymaps in our WAN Routers 7200 with IOS 12.2(12a). This policymaps are assinged to the ATM VC's with "service-policy output WAN".

So far everything works right. When I look at the policymaps with "show policy-map interface ATM 3/0.32" I see all policie hits and statistics.

Now I tried to us QDM 2.1 to see all this values but when I select the ATM 3/0.32 interface in the Graphic Applet dialog no values are offered for drawing.

I saw this behaviour only on the ATM Interfaces the Dialer Interfaces are working fine with QDM.

Any ideas available?

Thanks a lot for your help

Thomas

1 REPLY
New Member

Re: QDM and ATM VC's

It seems like the QDM 2.1 has a bug . Similar bugs have been found earlier. Check out for the open caveats in the following document:

Cisco QoS Device Manager Release and Installation Notes for Cisco Quality of Service Device Manager 2.1

http://www.cisco.com/en/US/products/sw/netmgtsw/ps2063/products_release_and_installation_notes09186a00800a99c5.html#xtocid3

101
Views
0
Helpful
1
Replies
CreatePlease to create content