Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QOS 6509 v12.2(17d)SXB10

6509 has WS-X6724-SFP, WS-X6748-GE-TX (RcvQ-1Q8T, xmtQ-1P3Q8T) and Sup720. I have questions about the command:

wrr-queue bandwidth 100 150 200

Q.1. With the above command, how will the bandwidth be divided if its a gig int?

Q.2. 1p3q8t supports DWERR (deficit weighted rr) but 'show queueing int' output below shows WRR only. How can i set DWRR ? Is it more efficient than WRR ?

s-ing-toronto0#sho queueing int gi3/2

Interface GigabitEthernet3/2 queueing strategy: Weighted Round-Robin

Port QoS is enabled

Trust state: trust DSCP

Extend trust state: not trusted [COS = 0]

Default COS is 0

Queueing Mode In Tx direction: mode-cos

Transmit queues [type = 1p3q8t]:

Queue Id Scheduling Num of thresholds

01 WRR 08

02 WRR 08

03 WRR 08

04 Priority 01

1 REPLY
Silver

Re: QOS 6509 v12.2(17d)SXB10

to allocate bandwidth between standard transmit queue 1 (low priority) and standard transmit queue 2 (high priority), the wrr-queue bandwidth command is used. refer to the following link for the command reference :

http://www.cisco.com/en/US/products/hw/switches/ps708/products_command_reference_chapter09186a00801026fa.html#wp1085797

121
Views
0
Helpful
1
Replies