You can control bandwidth usage with rate limiting also known as policing. If you want to use the catalyst 2950 for this application then you have to make sure the Catalyst has the IOS EI (Enhanced Image) because polcing is not possible with the 2950 IOS SI (Standard Image) and it cannot be upgraded to Enhanced Image without a hardware upgrade (new switch).
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...