For our edge switches, we have recently replaced 6509/sup1 switches with 6509E/sup720's. Part of our configuration applies a QoS service-policy to each interface, but when we do so, we get tons of "%QM-4-AGG_POL_EXCEEDED: QoS Hardware Resources Exceeded : Out of Aggregate policers" messages and it does not apply the service policy to all the interfaces. (There are 2xsup720-3B, 1x6408-GBIC, and 6xWS-X6148A-45AF in the switches).
What do I need to do to the config (see attched) to correctly apply the QoS policy to all interfaces on the switch?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...