I am trying that right now although I am having some problems getting the QoS policy to apply even though it is in the config. I am working with TAC. Going to try some differennt IOS versions to see what happens. e-me if you want at email@example.com to discuss more in detail.
I have Alcatel IP phone working at home via ASYNCHRONOUS remote connection to 4400 PBX on 2 Cisco routers (3640 with MICA and 3800, worked OK with 2500 as well) with IP TCP and RTP header compressions enabled and PQ. Works fine on auxiliary port. As per CCO, it is supported on BRI as well.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...