Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS on protocol ID

I need to classify ingress traffic based on a protocol id on every interface of a Cat4507R. Below is a frame capture and the part I want to match is the Type: Unknown (0x8819).

Frame 1 (64 bytes on wire, 64 bytes captured)

Arrival Time: Sep 12, 2005 14:09:04.933618000

Time delta from previous packet: 0.000000000 seconds

Time since reference or first frame: 0.000000000 seconds

Frame Number: 1

Packet Length: 64 bytes

Capture Length: 64 bytes

Protocols in frame: eth:data

Ethernet II, Src: DigitekM_30:10:18 (00:50:5e:30:10:18), Dst: 01:60:2b:ff:ff:00 (01:60:2b:ff:ff:00)

Destination: 01:60:2b:ff:ff:00 (01:60:2b:ff:ff:00)

Source: DigitekM_30:10:18 (00:50:5e:30:10:18)

Type: Unknown (0x8819)

Data (50 bytes)

Is this possible being a layer 2 frame and any thoughts how to do it?

2 REPLIES
Bronze

Re: QoS on protocol ID

Yes, you should be able to classify the traffic based on the Protocol ID, check the following link for more information on configuration :

http://www.cisco.com/univercd/cc/td/doc/cisintwk/ito_doc/qos.htm

New Member

Re: QoS on protocol ID

Thanks for the link. Unfortunately, the type field is in the Ethernet frame header not the IP packet header. I have come to the conclusion that it is not possible to do this with IOS

267
Views
0
Helpful
2
Replies