We are running call centre business whre Qos trust boundary is defined on Nortel i2004 with 802.1q and edge switches (cat 2950) which trusts the cos values . This trust retains to Cat-6506's further ( Core-switches)
We have got a PBR on MSFC routing interfaces for re-mark DSCP values soas RTP=5 , Voip Control=3. _ this is becoz meridian ITG gives a diffrent diffserv Values to edge phone -
Since I defiend the same on MSFC PBR ( PFC2, MLS & CEF enabled ), my question is will this re-marking happends to all packests for the entire conversation or only for the first packet ?
I know that for the first packet to its destinations will be classified as per my rules, but how abt the subsequent packets?
sinjce this will be directly forwarded by MLS CEF, will the re-marking rule defined on MSFC will take into concern ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...