The trust setting for the 2950 is no trust. The 3700 also does not trust ports by default. Trusting cos on the switchport is fine as long as you are sure the device is setting cos correctly and the user connected to the phone is on separate vlan (so he cannot artificially prioritize his traffic). 2950 SI switch, connected to a router via 802.1q trunks for data and voiceVLANs. Because the 2950 SI does not support AutoQos.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...