Question about NAT Inside Source, Inside Destination, and Outside Source
I read the Cisco command references about "ip nat inside source", "inside destination", and "outside source", but couldn't have a clear understanding of how to associate the commands with "ip nat inside" and ip nat outside" configured for interfaces.
Does "ip nat inside source ..." translation only happen on the interface configured as "ip nat inside"?
Since NAT is a bidirectional action, what's the difference between "ip nat inside cource ..." and "ip nat inside destination ..."?
I've never used "ip nat outside source ...". In what cases would it be needed?
On an interface where there are NAT translation and also other actions such as policy map or IP Sec crypto map, would NAT happen before or after other actions?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.