the table version is the number of BGP updates processed. As some internal timers in BGP (f.e. scanner) are 60 seconds, it is not unlikely that it takes one minute before an update is processed and the table version increased by one.
If you want your changes to be announced immediately then execute the command
clear ip bgp [*|AS|peer-group PGname|neighborIP] OUT
Do not forget the "OUT" otherwise the BGP session will be terminated, which is typically not needed.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...