Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question???

Cisco Router 2621 Router + 4E Module will appear below Messeng , Can you tall me how to solve ?? Thanks for Support!!

00:38:14: %AMDP2_FE-6-EXCESSCOLL: Ethernet1/0 TDR=1, TRC=0

00:38:44: %AMDP2_FE-6-EXCESSCOLL: Ethernet1/0 TDR=1, TRC=0

00:39:24: %AMDP2_FE-6-EXCESSCOLL: Ethernet1/0 TDR=1, TRC=0

interface Ethernet1/0

ip address 192.168.1.250 255.255.255.0

half-duplex

3 REPLIES
New Member

Re: Question???

The error you see in your log decodes as ;

%AMDP2_FE-6-EXCESSCOLL: [chars] TDR=[dec], TRC=[dec]

Ethernet or Fast Ethernet is detecting multiple collisions. This condition may occur under heavy loads.

A ' show interface ' may give you more clues, but if the segment is not busy then you have a problem with cabling and/or another device on that LAN.

best of luck

New Member

Re: Question???

That`s Right!!!

My customer deliver Mutlicast frame and contain huge Pics....

I have some confuse The Error messeng is normal to appear or not !!!

Could you tell me how to explorer with my customer ???

Thanks for Support!!!

New Member

Re: Question???

That`s Right!!!

My customer deliver Mutlicast frame and contain huge Pics....

I have some confuse The Error messeng is normal to appear or not !!!

Could you tell me how to explorer with my customer ???

Thanks for Support!!!

324
Views
0
Helpful
3
Replies
CreatePlease to create content