"CIP microcode not found" error message during bootup of C7507
On Cisco 7507 router during installation of new CIP microcode (CIP-27-21.bin) we have encountered a problem. During router restart we received information on the console "CIP microcode not found" (unfortunatelly we do not have logs from that day). After that we had problems with channel interfaces (it didn't go up). Then we downgraded CIP microcode (to previous ver. 27-7), but there still was the error message (the same as before). But we were able to bring up channel interfaces. We're not sure if the error message during start of Cisco 7507 router is a normal behaviour (?). Maybe the router first must load IOS to properly load CIP microcode - but then what for is the error message?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...