Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

"Class"-based config for interfaces?

Is there a way to make a "class" for an interface that contains the config for an interface, and then specify that class in the interface config? This is for an ATM interface.

I see that you can make a vc-class for individual PVCs on an ATM interface, but I just want to make a general config for a large number of ATM interfaces with identical configurations, not just the pvc part of the interface.

2 REPLIES
New Member

Re: "Class"-based config for interfaces?

New Member

Re: "Class"-based config for interfaces?

Thanks for the reply. But I already knew you could make a vc class for an ATM interface, but there are only pvc type parameters you can specify for that class. You can't specify that the interface is in a bridge group, or give it an "ip helper-address", etc. I just wanted to know if there is a "general interface class" I can use to put config commands that apply to interfaces in general. Not just pvc parameters.

108
Views
0
Helpful
2
Replies