Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

"dhcpd auto_config" equivalent on a router?

I'm trying to pass the default router and DNS on a dynamically configured external interface to the inside of my network via DHCP. On a PIX you would use the "dhcpd auto_config" command to pass through this information from the outside to the inside. How can this be done on a router such as a 2800?

I don't think IP Helper is the solution because if I understand it correctly it will will allow public broadcasts to pass through to the LAN. Correct me if I'm wrong though.

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: "dhcpd auto_config" equivalent on a router?

Hi,

I believe it may be possible by using the 'import all' command under the 'ip dhcp pool' configuration.

The following link describes this feature:

http://www.cisco.com/warp/public/105/dhcp_ser.html

Hope that helps - pls rate the post if it does.

Paresh

2 REPLIES
Purple

Re: "dhcpd auto_config" equivalent on a router?

Hi,

I believe it may be possible by using the 'import all' command under the 'ip dhcp pool' configuration.

The following link describes this feature:

http://www.cisco.com/warp/public/105/dhcp_ser.html

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: "dhcpd auto_config" equivalent on a router?

That worked, thank you!

583
Views
0
Helpful
2
Replies
CreatePlease to create content