I have a 6509 and which gives me something like " module 1 has inband error" message... I lost connectivity to this switch, only console works. After I consoled in, sh cdp give no entry!! I have at lease three up-links active and some trunks connecting to other 6509.
All these may caused by adding and access 4000, which is using dot1q trunk and native vlan 100 for the trunk.
By the way, I can't telnet out from the switch. Anyone saw this before?
Are you seeing something similar to the following?
01. 9/25/2002,12:28:07: InbandPingProcessFailure:Module 1 not responding over inband
02. 9/25/2002,12:28:32: ProcessStatusPing:Module 1 not responding over SCP
03. 9/25/2002,12:28:32: ProcessStatusPing:Module 1 not responding... resetting module
Did you have any STP loops/High CPU at the time of the crash? The above messages are printed when the Supervisor's CPU gets pegged high. There was a bug file for this kind of crash saying the switch should not crash under these circumstances and is fixed now.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...