The "No Shutdown" command does not seem to work on my Cisco 1605R with IOS 12.0.4T. Why is this? After I put "no shutdown" on interface ethernet 1. Then showrun, "no shutdown" was not listed anywhere. Does it mean that "no shutdown" does not work on this router????
"no shutdown" won't show up in the configuration on any router, as it's the default. If you enter "shutdown", you'll see it in the configuration, and then if you enter "no shutdown", you won't see "shutdown" anymore.
Not to be a wisenheimer but did your interface come out of the administratively down/down state after you issued the "no shut" command ? If your answer is yes, the command works. I haven't been on a 2600 lately but I can tell you that I can't remember seeing the "no shut" command appear in any of my configs on other platforms.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...