"rate limit" on a 4912g switch

[rkazala]

Is it possible to rate limit a port on a 4912g (catos) gige switch to say, 400Mbps? I've seen service-policy on IOS switches, but can't find anything similar for catos. Some examples would be great.

My alternative is using CAR on a 6500 switch with a sup2 on vlan, however that's not quite the route I'd like to go. While on this subject, is anyone familiar with the impacts on the sup2 when using CAR?

[Prashanth Krishnappa]

CAT4912 does not support rate limiting. Sup2 with PFC2 in 6500 does not support rate limiting as well on ethernet/VLAN interfaces, but you can use policing(Sup2/PFC2 supports only ingress policing)

http://www.cisco.com/warp/public/473/102.html