I have a few 4006 switches that do not appear to have all the available errdisable commands (duplex-mismatch is not listed on most) All the 4006's are running at least Cat5.4+, one is running Cat8.4(8)GLX-k9 (output from command listed below) I could not locate any info searching through the docs except that it is listed in the 8.3/8.4 command reference as an option for this command.
SWITCH4006 (enable) set errdisable-timeout enable ?
bpdu-guard BPDU Port-guard
channel-misconfig Channel misconfiguration
udld UDLD
other Reasons other than the above
all Apply errDisable timeout to all reasons
SWITCH4006 (enable)
The above is all that is listed on a 4006 running CatOS 8.4(8)GLX k9. Has anyone else noticed this or have a solution