Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

"set errdisable-timeout" command missing options?

I have a few 4006 switches that do not appear to have all the available errdisable commands (duplex-mismatch is not listed on most) All the 4006's are running at least Cat5.4+, one is running Cat8.4(8)GLX-k9 (output from command listed below) I could not locate any info searching through the docs except that it is listed in the 8.3/8.4 command reference as an option for this command.

SWITCH4006 (enable) set errdisable-timeout enable ?

bpdu-guard BPDU Port-guard

channel-misconfig Channel misconfiguration

udld UDLD

other Reasons other than the above

all Apply errDisable timeout to all reasons

SWITCH4006 (enable)

The above is all that is listed on a 4006 running CatOS 8.4(8)GLX k9. Has anyone else noticed this or have a solution

1 REPLY

Re: "set errdisable-timeout" command missing options?

4500 series 8.4.x does seem to show that option.

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_command_reference_chapter09186a00801f61e2.html#wp1024649

I am not sure if this feature is available for the 4006 in the same version.

243
Views
0
Helpful
1
Replies