Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

"show ip mroute active" output possible bug?

Please can someone tell me what the output "Rate: -56 pps/104 kbps(1sec), " on group 239.255.0.3 means. I don't understand the minus sign. Is this a bug?

Many thx

Router>sh ip mroute act 1

Active IP Multicast Sources - sending >= 1 kbps

Group: 239.255.0.1, (?)

Source: 30.26.1.118 (?)

Rate: 12 pps/25 kbps(1sec), 12 kbps(last 55 secs), 20 kbps(life avg)

Source: 30.41.100.35 (?)

Rate: 4 pps/9 kbps(1sec), 9 kbps(last 17 secs), 3 kbps(life avg)

Source: 30.53.1.139 (?)

Rate: 35 pps/75 kbps(1sec), 76 kbps(last 46 secs), 22 kbps(life avg)

Group: 239.255.0.3, (?)

Source: 30.25.1.138 (?)

Rate: -56 pps/104 kbps(1sec), 107 kbps(last 54 secs), 1 kbps(life avg)

Router> sh ver

Cisco Internetwork Operating System Software

IOS (tm) MSFC2 Software (C6MSFC2-JSV-M), Version 12.1(8a)E5, EARLY DEPLOYMENT RE

1 REPLY
New Member

Re: "show ip mroute active" output possible bug?

Usually this means the packets are getting dropped for a variety of reasons. I would guess in your case its an RPF failure or you have no Outgoing Interface (OIF) for that group. Check your mroute table 'show ip mroute 239.255.0.3' and see if it has any interfaces in forwarding state.

629
Views
0
Helpful
1
Replies