cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
277
Views
0
Helpful
1
Replies

"show test" command in Catalyst-6500.

shlomi-cohen
Level 1
Level 1

When I'm typing the "show test" command in Catalyst-6500,

there is parameter under the Environmental Status section,

VTT1,VTT2, VTT3, what those parameters means?

what steps do i need to take when this test failed.

getting: F, instead: .

1 Reply 1

Prashanth Krishnappa
Cisco Employee
Cisco Employee

Voltage Termination (VTT) module terminates signals on the Catalyst switching bus.

If it has failed, you'll need to replace the VTT module which resides in the chassis backplane

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10498.htm

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: