Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Rate Limit Frame Relay Link

Hi ciscoer,

I have a Frame Relay link 64 kbps. How to configure one PC with IP 192.168.10.200 to utilize the bandwitdh only 25% from 64 kbps Frame Relay link. Any sample config/link?

Thank You

HATO

5 REPLIES
Bronze

Re: Rate Limit Frame Relay Link

If you want to impose a hard limit (i.e. the pc can never use more than 25% even if more is available), use CAR:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt1/qcfclass.htm#1001048

If you only want to limit the PC to 25% when there is congestion, use FRTS with custom queuing:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/qos_c/qcprt4/qcdfrts.htm

hth

Herbert

Silver

Re: Rate Limit Frame Relay Link

you can use low latency queueing

access-list 1 permit 192.168.10.200

class-map limit

match access-group 1

policy-map 25percent

class limit

priority percent 25

int s0.1

service-polcy output 25percent

New Member

Re: Rate Limit Frame Relay Link

Thank You for your quick response.

HATO

New Member

Re: Rate Limit Frame Relay Link

HI......

Would you help me? After configure as you said. The "service-policy output 25percent" cannot implement in subinterface. How to counteract this msg?

Thank you

Silver

Re: Rate Limit Frame Relay Link

can you paste in a sh run

95
Views
0
Helpful
5
Replies