it seems like again we have only input rate-limit ... via service-policy input name .... and no ... output.
all the docs i've read states egress side doesn't have policing function.
is there a way to limit bandwidth usage on a port both directions in/out with a 2950 switch?
ps: i know i might get the result i want if i will apply input policy on the trunk port - but it says in the docs that in such a case all the vlans will go through that policy ... which means i'll have to group customers in the same switch based on their bandwidth requirements :))
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.