I have a Cisco 3745 in a small pop and need to connect two rate limited Ethernet customers. I'm going to utilize a 3550 to provide the interfaces for the pop LAN and the interfaces for the two customers. My question is three fold:
1. Can you rate limit a vlan or only physical interfaces?
(One customer has expressed the desire to have two diffrent Ethernet connections for redundancy)
2. Only layer two is required to rate limit (Correct?)
3. Is the correct syntax:
rate-limit input 1000000 16000 32768 conform-action transmit exceed-action drop
rate-limit output 1000000 16000 32768 conform-action transmit exceed-action drop
To allow 1Mb input and ouput with excess burst upto 32kb.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...