I have two 12008 GSR's on the edge of my network. For WAN circuits I have 1 ds3 (ISP A) going to one GSR and a ds3 (ISP B) and 1000Gigethernet/sonet (ISP C) going to the other GSR. I am running BGP4 with all three providers and I am load sharing accross all three interfaces. Both of the ds3's are burstable but my ISP C has put a 20MB cap on the Gigethernet circuit. During peak periods I am dropping packets on the Gigethernet circuit. What is the best command to use to let my router know that there is only 20MB of bandwidth available on that interface? I have tried the Bandwidth command bu that does not seem to be working.
You might want to try GTS , we have a very similar type of setup where we have to limit an ethernet interface to conform to incoming serial bandwidth. We use GTS to do this but it might not suite your requirement , check it out at
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.